Labels:bird | book | bulletin board | chat room | reckoner | sky OCR: Installation Instructions Connecting AC Power Connecting AC Power WARNING Failure to select the proper voltage for operation WILL DAMAGE YOUR PE/2 CHASSIS !!! The Power Supply located in the PE/2 is switch selectable for either 110or 220 Volts AC operation. This switch is located on the rear of the chassis and MUST be set to the correct voltage for your use INCORRECT selection of this switch WILL DAMAGE the PE/2 if power is then applied DOUBLE CHECK before plugging the PE/2 into a wall outlet To select the correct voltage locate the black switch on the back of the PE/2 as shown in Figure 5. The voltage selected is shown on the switch for this position. If this is correct you are done not move the black FIGURE5 portion of the switch left or right until the correct voltage is displayed. Volt ...
